300-135 Prüfungsvorbereitung

300-135 Prüfungsvorbereitung Studienmaterial deutsch Troubleshooting and Maintaining Cisco IP Networks (TSHOOT) www.it-pruefungen.de

QUESTION: 1
- (Topic 0)

Exhibit:

A network administrator is troubleshooting an EIGRP connection between RouterA, IP address 10.1.2.1, and RouterB, IP address 10.1.2.2. Given the debug output on RouterA, which two statements are true? (Choose two.)

A. RouterA received a hello packet with mismatched autonomous system numbers.
B. RouterA received a hello packet with mismatched hello timers.
C. RouterA received a hello packet with mismatched authentication parameters.
D. RouterA received a hello packet with mismatched metric-calculation mechanisms.
E. RouterA will form an adjacency with RouterB.
F. RouterA will not form an adjacency with RouterB.

Answer: D,F

QUESTION: 2
- (Topic 0)

When troubleshooting an EIGRP connectivity problem, you notice that two connected EIGRP routers are not becoming EIGRP neighbors. A ping between the two routers was successful. What is the next thing that should be checked?

A. Verify that the EIGRP hello and hold timers match exactly.
B. Verify that EIGRP broadcast packets are not being dropped between the two routers with the show ip EIGRP peer command.
C. Verify that EIGRP broadcast packets are not being dropped between the two routers with the show ip EIGRP traffic command.
D. Verify that EIGRP is enabled for the appropriate networks on the local and neighboring router.

Answer: D

QUESTION: 3
- (Topic 0)

Refer to the exhibit.

How would you confirm on R1 that load balancing is actually occurring on the default- network (0.0.0.0)?

A. Use ping and the show ip route command to confirm the timers for each default network resets to 0.
B. Load balancing does not occur over default networks; the second route will only be used for failover.
C. Use an extended ping along with repeated show ip route commands to confirm the gateway of last resort address toggles back and forth.
D. Use the traceroute command to an address that is not explicitly in the routing table.

Answer: D

IT-Prüfungen 300-135 Troubleshooting and Maintaining Cisco IP Networks (TSHOOT)  https://www.it-pruefungen.de/300-135.htm

QUESTION: 4
- (Topic 0)

Which IPsec mode will encrypt a GRE tunnel to provide multiprotocol support and reduced overhead?

A. 3DES
B. multipoint GRE
C. tunnel
D. transport

Answer: D

QUESTION: 5
- (Topic 0)

Which three features are benefits of using GRE tunnels in conjunction with IPsec for building site-to-site VPNs? (Choose three.)

A. allows dynamic routing over the tunnel
B. supports multi-protocol (non-IP) traffic over the tunnel
C. reduces IPsec headers overhead since tunnel mode is used
D. simplifies the ACL used in the crypto map
E. uses Virtual Tunnel Interface (VTI) to simplify the IPsec VPN configuration

Answer: A,B,D

300-135 Prüfungsfragen Troubleshooting and Maintaining Cisco IP Networks (TSHOOT) www.it-pruefungen.de

QUESTION: 6
- (Topic 0)

Which statement is true about an IPsec/GRE tunnel?

A. The GRE tunnel source and destination addresses are specified within the IPsec transform set.
B. An IPsec/GRE tunnel must use IPsec tunnel mode.
C. GRE encapsulation occurs before the IPsec encryption process.
D. Crypto map ACL is not needed to match which traffic will be protected.

Answer: C